Box Spring. Sunday , February 11th , 2018 - 13:23:59 PM
Of all the benefits to platform beds, none is as helpful and noticeable as the end to box springs. Box springs have always been more of a hassle than anything else, and can even ruin the comfort brought about by a nice, new mattress. The idea is that a standard bed frame cannot support a mattress directly. The box spring rests between the mattress and the frame, providing "durable" balance and foundation. In reality, the box spring creaks, wears out, and even breaks after continuous use. The problem is introducing an additional element to the bed - an element that typically doesnt have the strength to last very long without becoming an issue. Platform beds remedy this problem by removing the box spring from the equation altogether.
Some are made from 100% cotton, some are made from polyester and some are a mix of both fabrics or are made from other materials. Some have membrane coatings bonded to them to make them dust mite and pet dander proof and some do not have any membrane coatings at all because the fabric is so tightly woven together, the dust mite and pet dander allergen cannot penetrate through the fabric at all. The big concern for most people is for their dust mite encasings to be smooth and cool for better sleeping comfort. In the old days some mattress encasings were made from crunchy plastic or stiff vinyl materials that were loud and uncomfortable to sleep on. Some of these materials would also quickly melt or come apart in a hot dryer.
If you require a box spring for your mattress If your purpose for a platform bed is to have a lower profile that adding a box spring might not make any sense. There are platform beds that have that have a much lower foundation that can easily set up the box spring and mattress. This way you can get the best setup for your mattress and still have that desire low profile. Does your Platform Bed have Slats? Slats can take place for the box spring. But once again you should refer to your manufactures guide. Depending on your mattress thickness, you could possibly feel the sagging around the spacing of your slats. Off course the closer the slats the better, but most of the times the slats are built in and only able to adjust them minimally. Using Plywood Deck If all else fails then the best solution is to measure the width and length of the bed. Use these measurements and cut out a plywood deck. I would recommend cutting them into 2 or 3 smaller pieces. Cutting one large plywood deck can be difficult, especially if you have a larger size like a king or queen. Once again though check with your manufacturers guide. The flat foundation could possibly make the mattress less comfortable.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does gpumax claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.